In2fords.... slave pic

[Splashman]

Here ya go Jeremy, hope this helps. If you need a diff angle let me know

http://www.rrorc.com/gallery/data/500/medium/slave.JPG

[in2fords]

YEA, WE'RE BACK ON!!
looks just like mine. I tried it in the threaded hole and the blank hole but it was a little low, I put it in the 2 upper threaded holes and its a little high. Ill put it in the lower position again and see if it is any better. so far your the only one I know running this setup so your the one I get to bombard with questions:D
thanks, Jeremy.

[Splashman]

YEA, WE'RE BACK ON!!
looks just like mine. I tried it in the threaded hole and the blank hole but it was a little low, I put it in the 2 upper threaded holes and its a little high. Ill put it in the lower position again and see if it is any better. so far your the only one I know running this setup so your the one I get to bombard with questions:D
thanks, Jeremy.

LOL it's all good. I'm pretty sure mine isn't straight across. It's a little offset, but not much

[Taxx]

Thats not what I imagined when I saw the title of this thread :shake: